Commissioning And Maintenance; Releasing The Transducer; Dimensional Drawing; Instruments Admissions - OSI DW5 Mode D'emploi

Fig. 5. Declaration to type label.

6. Commissioning and maintenance

Switch on the power supply and the measuring input. It is
possible during the operation to disconnect the output line and
to connect a check instrument, e.g. for a functional test.
No maintenance is required.

7. Releasing the transducer

Release the transducer from a top-hat rail as shown in
Fig. 6.
Fig. 6
7004-00058-A Rev A.indd

8. Dimensional drawing

112.5
114.1
Fig. 7. Housing P18/105 clipped onto a top-hat rail (35 15 mm or
357.5 mm, acc. to EN 50 022)

9. Instruments admissions

CSA approved for USA and Canada
fi le-nr. 204767
FCC Compliance and Canadian DOC Statement
This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to
both part 15 of the FCC Rules and the radio interference
regulations of the Canadian Department of Communi-
cations: These limits are designed to provide reasona-
ble protection against harmful interference when the
equipment is operated in a commercial environment.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accor-
dance with the instruction manual, may cause harmful
interference to radio communications. Operation of this
equipment in a residential area is like to cause harmful
interference in which case the user will be required to
correct the interference at his own expense.
Page 6 of 16
15 16 17 18
1 2 3 4 5 6 7 8 9 10 11 12 13 14
105
12/29/14