Yamaha MCR-040/140 Mode D'emploi page 20

TROUBLESHOOTING
The following status messages appear only if you are using MCR-140.
Status message
iPod Linked
iPod
iPod Unlinked
iPod Low Batt.
The following LED statuses of the status indicator refer to the transmitter.
LED status
Off
Flashes green
Flashes green once
Lights up green
Lights up green and
flashes red for 2
seconds
Lights up green and
keeps flashing red
Flashes red
Flashes red once
Flashes red 2 times
continuously
(regardless of green
status)
16
En
Cause
Wireless connection was successful.
Wireless connection has disconnected.
The battery of the iPod is getting flat.
Transmitter status
The transmitter is in standby mode.
An iPod is not connected or wireless
communication has not been established.
Connection in progress.
Adjusting the volume level or operating
with the remote control.
Wireless communication between the
unit and transmitter is established.
An unsupported iPod is connected.
Connection failed.
Error occurs.
The volume of the unit is set to maximum
or minimum.
The battery of the iPod is low.
Remedy
Connect the iPod to the transmitter and start
playback.
Set it in the charging cradle.
Remedy
Please wait.
Only iPod (5th generation), iPod classic, iPod nano,
and iPod touch are supported.
Connect again.
Remove the iPod from the transmitter, and connect
again.
Set the iPod in the charging cradle.
page
5
5
page
—
5
8
8
5