Turntable Cover - Teac LP-R500 Mode D'emploi

Masquer les pouces Voir aussi pour LP-R500:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

About CD-R and CD-RW discs
CD-R discs can be recorded once only. Once they have been used
for recording, they cannot be erased or re-recorded.
However, if space is available on the disc (and the disc has not
been finalized), additional material can be recorded.
By contrast, a CD-RW disc can be used in much the same way as a
CD-R disc, but the last track or tracks recorded can be erased, and
the space on the disc can be re-used for other recordings.
However, you should note that an audio CD created using a CD-
RW disc may not play back satisfactorily on every audio CD player.
CD-R, by contrast, may be played satisfactorily on the majority of
audio CD players.
Finalizing
Although audio data may be written on a CD-R or CD-RW disc, a
standard CD player will not be able to play back the audio until a
final table of contents (TOC) has been written at the start of the
disc.
The process of writing this table of contents is known as
"finalizing". Once this has been done, no further data can be
written to the disc.
Note that a CD-RW disc that has been finalized can be
"unfinalized". This allows further tracks to be recorded to the disc,
provided that there is space on the disc.
< Repeat, shuffle and programmed playback do not work with
unfinalized (NO TOC) discs.
Recordable discs
In this manual, we use the term "recordable" disc to describe a
CD-R or CD-RW disc that has not been finalized, and has enough
space to record.
If a CD-RW disc for High speed (4X or more) is recorded with this
unit, the disc may not be able to be played back by some other
CD recorder.

Turntable Cover

To attach the turntable cover
1. Slide the hinges into the hinge fittings on both sides of the rear of
the turntable.
2. Place the turntable cover hinge fittings over the top portion of
the hinges and slide the cover down into place.
To detach the turntable cover
Hold the cover on both sides and gently pull upward to remove
it from the hinges.
How to open/close the turntable cover
To Open
Lift the turntable cover halfway until it stops.
< The cover will now stay open.
To Close
Slowly lower the cover until it touches the turntable base.
Note:
Make sure you grasp the cover by the front edge to avoid
removing hinges.
Be careful not to pinch your fingers when the cover closes.
7

Publicité

Table des Matières
loading

Table des Matières