Teac LP-R500 Mode D'emploi page 11

H Skip/Search (.m/,/), TUNING (
In CD mode, use these buttons to skip tracks.
Hold down these buttons to search for a part of a track.
In FM/AM mode, use these buttons to tune in a station.
I RECORD
Use this button to enter record pause mode.
J CD operation buttons
PLAY/PAUSE (y/J)
Use this button to start or pause playback and recording.
STOP (H)
Use this button to stop playback or recording.
K Speakers (stereo)
L
OPEN/CLOSE (L)
Use this button to open and close the disc tray.
M
Remote Sensor
When operating the remote control unit, point it towards the
REMOTE SENSOR.
N VOLUME
Turn this knob to adjust the volume.
O
Disc Tray
P
REC LEVEL
In record pause mode, use this knob to adjust the recording level.
Q
PHONES
For private listening, first reduce the volume level to minimum.
Then insert the plug from your headphones into the PHONES
jack, and adjust the volume by turning the VOLUME knob. The
sound from speakers will be cut off while the headphones are
plugged in.
< Do not turn the unit on or off, or insert or pull out the
headphones jack while wearing the headphones.
(Excessive sounds may occur from the headphones.)
< The sound from speakers will be cut off while the headphones
are plugged in.
R
PROGRAM
In CD mode, use this button to program tracks.
S
CLEAR
In CD mode, use this button to clear programmed tracks.
T
REPEAT
In CD mode, use this button to select repeat mode of CD.
U
DISPLAY
In CD mode, use this button to change the display.
) V SHUFFLE
In CD mode, use this button for shuffle playback.
Note:
To simplify explanations, instructions refer to names of buttons
and controls on the front panel, making no mention of the use of
remote control unit.
For European Customers
Information for Users on Collection and Disposal of Old
Equipment and used Batteries
These symbols on the products, packaging, and/or
accompanying documents mean that used electrical and
electronic products and batteries should not be mixed with
general household waste. For proper treatment, recovery and
recycling of old products and used batteries, please take them
to applicable collection points, in accordance with your national
legislation and the Directives 2002/96/EC and 2006/66/EC.
By disposing of these products and batteries correctly, you
will help to save valuable resources and prevent any potential
negative effects on human health and the environment which
could otherwise arise from inappropriate waste handling.
For more information about collection and recycling of old
products and batteries, please contact your local municipality,
your waste disposal service or the point of sale where you
purchased the items.
Information on Disposal in other Countries outside the
European Union
These symbols are only valid in the European Union. If
you wish to discard these items, please contact your local
authorities or dealer and ask for the correct method of
disposal.
Note for the battery symbol (bottom right two symbol
examples):
This symbol might be used in combination with a chemical
symbol. In this case it complies with the requirement set by the
Directive for the chemical involved.
11