Fakir DR 26 Mode D'emploi page 24

Operating and use / Adding water
The spray jets and steam lances are
extremely well suited to clean and remove
dirt in difficult places: in the sanitary area
of washbasins (taps, drains, overflows),
baths or showers, shower divider profiles,
toilets, bidets, etc., cracks, gaps and other
areas which are difficult to reach e.g. ribs
Adding water
Once all the water has been used, this is
indicated by indicator D lighting up ( pages
22-24).Before adding water whilst the
machine is still warm, please take note of
the following:
• Press the switch F on the handle and
allow the remaining steam to escape
completely
24
on radiators joins between ceramic or
stone files, in the kitchen on cookers, cup-
boards, sinks etc.
For especially difficult or very dirty areas
the small round brush with plastic brist-
les or brass bristles can be pushed onto
the spray jet.
The window jet is used to clean all types
of glass surfaces. Steam the glass. Then,
without steam, use the rubber lip of the jet
to wipe away the dirt and take it up with a
cloth/sponge.
If the difference in temperature between
the inside and outside of the window
panes is very large, the glass might
break. Therefore the windows must
be pre-warmed. To do this hold the
window jet in front of the window pane at a
distance of approx. 5 – 10 cm, move it
around with a waving motion to allow the
heat to take effect.
• Remove the plug from the mains
socket.
• Allow device to cool down completely.
• Carefully open safety cap and before
screwing out completely allow any resi-
dual steam to escape.
• Fill in a maximum of 1,5 l of water and
then tighten safety cap again ( page
21).
• Push plug back into mains socket.