Circuit Diagram; Safety Prescriptions - Velleman KSR10 Notice D'emploi

9 Troubleshooting
1. Ensure all wirings are correct. Please refer to
2. If the robotic arm does not respond to any of the controls, check the BATTERY and GND connectors. Also check
if the batteries are correctly inserted. Please refer to
3. If the robotic arm moves in the opposite direction of the desired control, check if wirings M1, M2, M3, M4 and M5
have not been inversed. Please refer to
4. If the searchlight does not function, check if the L connector is correctly wired. Please refer to
10

Circuit Diagram

11

Safety Prescriptions

• Removal and replacement of batteries should be carried out by an adult or under adult supervision.
• Do not recharge non-rechargeable batteries. Remove exhausted batteries from the product to avoid leakage.
• Do not mix old and new batteries or batteries of different types.
• The use of rechargeable batteries or mercury-oxide batteries is not recommended for this product.
• Avoid short-circuiting the contacts.
Use this device with original accessories only. Velleman nv cannot be held responsible in the event of
damage or injury resulted from (incorrect) use of this device.
For more info concerning this product, please visit our website www.velleman.eu.
The information in this manual is subject to change without prior notice.
KSR10_v4
on pages 56 ~ 57.
on page 46.
on pages 56 ~ 57.
Wired Control Box
Robotic Arm
- 9 -
on pages 56 ~ 57.
VELLEMAN