Rotating InStyler
®
Can I use the InStyler as a heated curling tong?
Of course you can! You can get amazing curls by simply wrapping and closing sec-
tions of hair around the rotating heated barrel!
The heated cylinder rotates. Will that not tangle my hair?
No. The rotating heated barrel's surface is quite smooth, which stops the hair from
becoming tangled.
What is the barrel diameter?
The barrel diameter measures 32mm.
What are the bristles made from?
They are made from heat-resistant nylon.
What is the InStyler's power wattage?
The InStyler uses 220~240 volts, 50 Hz and 65 watts.
How do I switch the InStyler on?
Check that you have plugged the InStyler into a power socket. Push the power
button. The LED display should light up and start to flash. Once the display stops
flashing it means that the InStyler is ready to use. You must close the handle to make
the appliance rotate.
How do I get the InStyler to rotate?
You must close the handle and it will begin rotating automatically.
What if my InStyler does not heat up?
Check that the InStyler has been plugged in properly. Press the power button. The LED
display should light up and start to flash. Once the display stops flashing it means the
InStyler has reached its temperature setting and is ready to use.
Why does the LED display start to flash whenever I use the InStyler?
This is normal because the temperature will fluctuate during use. Provided the InStyler
has been allowed to reach the full temperature after it has been switched on (fully
illuminated LED display), you can continue to use it, even when the light is flashing.
How do I clean my InStyler?
When you clean your InStyler, disconnect it from the power source and ensure that
it has completely cooled down. Wipe the outside surface with a damp cloth. Wring
the cloth out fully to remove any excess water before using it on the InStyler. You can
remove ground-in dirt using a soft damp cloth with a mild soap. The precision brushes
can be lightly scrubbed if required using a damp cloth to remove product build-up.
Use a mild soap if required. Ensure your InStyler is completely dry before plugging
it in.
24
stylerTitanium-Manual-DE-EN-FR-IT-NL-20141008.indd 24
08.10.14 16:21