Installation And Connections; Additional Information - Pioneer S-DJ50X Mode D'emploi

Installation and Connections

How to Install
A speaker's playback sound is delicately influenced by
conditions in the listening room. To produce optimum listening
conditions, take due consideration of the conditions of your
installation location before beginning actual installation.
 Place the speakers at ear level.
 For a natural stereo effect, the right and left speakers should
be installed in symmetrical and equidistant positions from the
listening position.
Connections
 When making or changing connections, always turn off the
power and disconnect the power cord from its outlet.
 Also, be sure to read the operating instructions for the other
components to which you are connecting these speakers.
 Do not plug in the power cord until all other connections have
been completed.
 Use only the furnished accessory power cord.

Additional Information

Troubleshooting
 If you think you are experiencing a malfunction with this unit, check the following items. Also check other devices connected to the
unit. If the problem persists, consult your dealer for service.
 On occasion, the unit may fail to operate properly due to static electricity or other external conditions. In this event, disconnect the
power cord and wait for five minutes or more, then reconnect the power cord and check for proper operation.
Symptom
No power
No sound from connected audio
devices, or sound is very small.
Illumination (POWER indicator)
remains turned off.
Speakers do not resume (turn on) from
standby mode.
Sound is distorted.
Feedback (continuous howling sound)
Items to Check
Is power cord connected properly?
Has connected audio device been set properly?
Is connection cable connected properly?
Are connectors or plugs dirty?
Is the sound volume set properly?
Is the power turned on?
Is the auto standby function on?
Is the power turned on?
Is the auto standby function on?
Is the level of the input signal low?
Is the sound level set properly?
Is the output level of the connected audio device set
properly?
Is the sound volume set properly?
 Speakers should ideally be located at 30 ° angles from the
listening position (together forming a total 60 ° angle), and
rotated inward to face the listening position.
50 °～ 60 °
CAUTION
To promote proper cooling, please assure that sufficient space
is preserved between the speakers and nearby walls or other
components (minimum 30 cm or more above, behind, and to
right and left sides of each speaker). Leaving insufficient space
between the speaker and walls or other components may lead to
rising interior temperatures, leading to malfunction or damage.
• Do not connect to both the XLR INPUT connector and the TRS
INPUT jack at the same time.
• Make sure to set the sound level at an appropriate level as
the input signals to the XLR INPUT connector (or TRS INPUT
jack) and RCA INPUT jack will be mixed together, affecting the
sound level.
Remedy
Connect power cord to outlet.
Set device's external input and sound volume properly.
Connect cables properly.
Clean connectors and plugs before connecting.
Turn the [LEVEL] dial on the rear panel clockwise and
turn up the volume.
Turn on the [POWER] switch on the rear panel.
Turn off the [POWER] switch on the rear panel once,
wait a few seconds, and then turn it back on.
Turn on the [POWER] switch on the rear panel.
Turn off the [POWER] switch on the rear panel once,
wait a few seconds, and then turn it back on.
Increase the level of the input signal.
Turn off the [AUTO STANDBY] switch to turn off the
auto standby function.
Slowly turn the [LEVEL] dial on the rear panel
counterclockwise and turn down the volume.
Adjust the output level of the connected audio device
properly.
Slowly turn the [LEVEL] dial on the rear panel
counterclockwise and turn down the volume.
5
En