Husqvarna W50P Manuel D'utilisation page 12

1. Stop the product fully and make sure that the
product is on level ground.
2. Remove the oil tank cap and dipstick (A).
A
3. Clean the oil from the dipstick.
4. Put the dipstick back fully into the oil tank.
5. Remove the dipstick.
6. Examine the engine oil level on the dipstick.
7. If the engine oil level is low (B), fill engine oil to the
edge of the oil tank hole (C).
8. Do a check of the engine oil level again.
9. Install the oil tank cap and dipstick.
To replace the engine oil
Note:
Drain the engine oil while the engine is warm.
Warm engine oil is faster to drain.
WARNING:
very hot and can cause burn injuries. Let the
engine become cool before you drain the
engine oil.
1. Put an applicable fuel container below the drain hole
on the engine.
12
C
B
The engine oil becomes
2. Remove the oil tank cap and dipstick (A).
B
A
3. Remove the drain plug (B) and sealing washer (C).
Discard the sealing washer.
4. Let the engine oil drain fully into the fuel container.
5. Install a new sealing washer and the drain plug.
6. Fill engine oil. Refer to
oil level on page 11 .
7. Install the oil tank cap and dipstick and tighten it.
8. Recycle the used engine oil at an approved disposal
location.
To do a check of the air filter
CAUTION:
cannot be fully cleaned or if it is damaged.
Do not operate the product with a damaged
air filter. A damaged air filter can cause
damage to the engine.
C
To do a check of the engine
Replace the air filter if it
1421 - 004 - 09.07.2020