To Stop The Product - Husqvarna W50P Manuel D'utilisation

5. Pull the starter rope handle (E) slowly until you feel
resistance.
E
6. Pull the starter rope handle quickly and with force
until the engine starts.
7. Move the starter rope handle back slowly into its
initial position to prevent damage to the product.
8. If the engine is cold, open the choke gradually as the
engine becomes warm.
To set the engine speed and pump
output
1. Move the throttle lever fully to the left to increase the
engine speed.
2. Do a check of the pump output.
3. Adjust the pump output with the throttle lever (A) if it
is necessary.
Note:
The pump output is related to the engine
speed and is adjusted with the throttle lever.
a) Move the throttle lever to the left to increase the
pump output.
b) Move the throttle lever to the right to decrease
the pump output.

To stop the product

WARNING:
immediately set the ON/OFF switch to the
OFF position to stop the engine.
10
A
If an emergency occurs,
1. Decrease the engine speed with the throttle lever
(A).
2. Set the ON/OFF switch (B) to the OFF position.
B
3. Set the fuel valve lever (C) to the OFF position.
C
4. After the product has stopped, clean the product.
To clean the product on page 13 .
Refer to
A
1421 - 004 - 09.07.2020