LENCO PIR-645 Mode D'emploi page 14

Note: You may need to adjust sound on your external device as required.
General Operation
Sleep
To set the sleep timer, press and hold Info/Menu button to enter Main Menu > Sleep,
rotate and press "-Vol+/OK/Tune" knob to select the sleep time.
Sleep Off/15mins/30mins/45mins/60mins
Setting Backlight
Press Info/Menu button to enter System Settings> Backlight, press "-Vol+/OK/Tune" knob
to confirm.
Rotate "-Vol+/OK/Tune" knob to select the backlight setting and press enter to confirm.
Timeout Off/10s/20s/30s/45s/60s/90s/120s/180s
On-level High/Medium/Low
Dim-level(idle) Medium/Low/Off
Alarm
When device is playing on mains power, to set or change an alarm, press Alarm button,
scroll and press "-Vol+/OK/Tune" knob to select alarm number (1/2) then configure the
following parameters:
Enable Off/Daily/Once/Weekends/Weekdays
Time 00:00 (adjust as necessary)
Mode Buzzer/Internet radio/DAB/FM
Preset Last listen or preset 1-40
Volume 10-32
To save these settings and set the alarm, scroll down and select Save.
On battery mode, the device doesn't support the alarm function.
Note:
If you press Back or Info/Menu button to exit the Alarm settings without saving, a
dialogue screen is displayed asking if you wish to save the changes or not.
Screen shows active set alarms with an icon at the bottom left.
At the set time, the alarm will sound. To temporarily silence it, press "-Vol+/OK/Tune"
knob repeatedly cycles through the snooze periods: 5mins/10mins/15mins/30mins.
14