König Electronic CMP-WNROUT50 Mode D'emploi page 5

LED INDICATORS
LED status
Status Green flash
Green
WAN LED
Green flash
Green
LAN LED
Green flash
Green
Green flash
Wi-Fi LED
Green fast flash
Dark green
BUTTON DEFINITION
WPS
Wireless On
(CMP-WNROUT55
only)
Reset
Description
CMP-WNROUT55
When wireless is switched on, press and hold this button (about 1 sec) to execute
WPS function
CMP-WNROUT60
1. When wireless is switched off, press and hold this button (about 1 sec) to
enable "Wireless Radio"
2. When wireless is switched on, press and hold this button (about 1 sec) to
execute WPS function
When wireless is switched off, press and hold this button (about 1 sec) to enable
"Wireless Radio"
CMP-WNROUT55
1. Press this button and switch on the device
2. Press and hold for about 3 – 4 seconds. The device will reset to the default
settings. Then the Status LED flashes every second in Normal status
Notice: If the Status LED flashes very fast, it means this button was pressed too
long. Please try again
CMP-WNROUT60
Press and hold this button for 6 seconds to reset to default settings. Release the
button when the device works simultaneously.
Description
Device status is working
RJ45 cable is plugged in
Data access
RJ45 cable is plugged in
Data access
Wi-Fi is on
Data access
Device is in WPS PBC mode
Wi-Fi is disabled
5