König Electronic CMP-WNROUT50 Mode D'emploi page 43

Configuration on NAT Router
Destination
192.168.0.1
192.168.0.0
So if, for example, the client 3 wanted to send an IP data gram to 192.168.0.2, it would use the above
table to determine that it had to go via 192.168.123.103 (a gateway),
And if it sends packets to 192.168.1.11 it will go via 192.168.123.216
Each rule can be enabled or disabled individually.
After Routing Table setting is configured, click the Save button.
Schedule Rule
You can set the schedule time to decide which service will be turned on or off. Select the "enable" item.
Press "Add New Rule"
You can write a rule name and set which day and what time should be scheduled by filling in the fields
"Start Time" and "End Time".The following example configures "ftp time" as everyday 14:10 to 16:20
Schedule Enable
Select if you want to enable the scheduler.
Edit
To edit the schedule rule.
Delete
To delete the schedule rule and the rule # of the rules behind the deleted one will decrease by one
automatically.
Schedule rule can be applied to virtual server and packet filter, for example:
Example 1: Virtual Server – Apply Rule#1 (ftp time: everyday 14:20 to 16:30)
Subnet Mask
255.255.255.0
255.255.255.0
Gateway
192.168.123.216
192.168.123.103
43
Hop
1
1
Enabled
ˇ
ˇ