König Electronic CMP-WNROUT50 Mode D'emploi page 18

PPTP: Some ISPs require the use of PPTP to connect to their services
First, please check and select the Static IP Address or Dynamic IP Address assigned by your ISP.
1. My IP Address and My Subnet Mask: the private IP address and subnet mask your ISP assigned to
you.
2. Server IP Address: the IP address of the PPTP server.
3. PPTP Account and Password: the account and password your ISP assigned to you. If you do not
want to change the password, keep the field empty.
3. Connection ID: optional. Input the connection ID if your ISP requires it.
4. Maximum Idle Time: the time of no activity to disconnect your PPTP session. Set it to zero or enable
Auto-reconnect to disable this feature. If Auto-Reconnect is enabled and the system has restarted or
the connection has been disconnected, the router will connect to the ISP automatically.
Connection Control: There are 3 modes to select:
Connect-on-demand: The device will connect to the ISP when the clients send outgoing packets.
Auto-Reconnect (Always-on): The device will connect to the ISP until the connection is established.
Manually: The device will not make the link until someone clicks "Connect" on the Status page.
L2TP: Some ISPs require the use of L2TP to connect to their services
First, please check your ISP assigned and select Static IP Address or Dynamic IP Address.
For example: Use Static
1. My IP Address and My Subnet Mask: the private IP address and subnet mask your ISP assigned to
you.
2. Server IP Address: the IP address of the PPTP server.
3. PPTP Account and Password: the account and password your ISP assigned to you. If you do not
want to change the password, leave this field blank.
4. Connection ID: optional. Input the connection ID if your ISP requires it.
5. Maximum Idle Time: the time of no activity to disconnect your PPTP session. Set it to zero or enable
Auto-reconnect to disable this feature. If Auto-Reconnect is enabled and the system has restarted or
the connection has been disconnected, the router will connect to the ISP automatically.
Connection Control: There are 3 modes to select:
Connect-on-demand: The device will link up with ISP when the clients send outgoing packets.
Auto-Reconnect (Always-on): The device will connect to the ISP until the connection is established.
Manually: The device will not connect until someone clicks "Connect" on the Status page.
18