Cooper Lighting Solutions B95 LED Instructions D'installation

IB519088EN
Installation Instructions – B95 LED
Instructions d'installation – B95 LED
Instrucciones de instalación – B95 LED
Risk of Fire, Electrical Shock, Cuts or other Casualty Hazards- Installation and maintenance of this
product must be performed by a qualified electrician. This product must be installed in accordance
with the applicable installation code by a person familiar with the construction and operation of the
product and hazards involved.
Risk of Fire and Electric Shock- Make certain power is OFF before starting installation or attempting
any maintenance. Disconnect power at fuse or circuit breaker.
Risk of Fire- Minimum 90°C supply conductors.
Risk of Burn- Disconnect power and allow fixture to cool before handling or servicing.
Risk of Personal Injury- Due to sharp edges, handle with care.
Must be very careful if power tools are used to install the fixture. Uncontrolled torque setting may
lead to thread/gasket damage or lens breakage.
Failure to comply with these instructions may result in death, serious bodily injury and property damage.
DISCLAIMER OF LIABILITY: Cooper Lighting Solutions assumes no liability for damages or losses of any kind
that may arise from the improper, careless, or negligent installation, handling or use of this product.
IMPORTANT: Read carefully before installing fixture. Retain for future reference.
NOTICE: These instructions do not claim to cover all details or variations in the equipment, procedure, or process
described, or to provide directions for meeting every possible contingency during installation, operation or
maintenance. When additional information is desired to satisfy a problem not covered sufficiently for user's
purpose, please contact your nearest representative.
NOTICE: Proper grounding is required to insure personal safety. Carefully observe grounding procedure under
installation section.
NOTICE: Fixture may become damaged and/or unstable if not installed properly.
Note: Specifications and dimensions subject to change without notice.
GENERAL: Upon receipt of fixture thoroughly inspect for any freight damage, which should be brought to the
attention of the delivery carrier. Compare the catalog description listed on the packing slip with the fixture label
on the housing to assure you have received the correct merchandise.
CLEANING: The reflector and lens may be cleaned with any non-abrasive cloth and mild detergent (i.e. 409 Cleaner).
Cleaning should be done on the lens at room temperature, and out of direct sunlight. To remove paint, lipstick,
marker, etc., the following solvents may be used:
RECOMMENDED:
a) A solution of three (3) parts alcohol, one (1) part TOLUOL.
OR
b) Four (4) parts alcohol, one (1) part Methylethylketone MEK). Also safe, but less effective: Naphtha, Butyl
Celiosolve, Kerosene.
WARNING
Brand Logo
reversed out of
black
INS # INS #