Cooper Lighting Solutions IRIS E-5 Série Instructions D'installation

ADI140856
Installation Instructions for Iris® E-5 Series of Elements, All SF
Options, All RAW Options
Instructions d'installation pour modèles d'éléments, E-5 de Iris®
Toutes les Options, SF Toutes les Options RAW
Instrucciones de Instalación para Iris® Serie E-5 de luminarias
Elements, Todas las Opciones, SF Todas las Opciones RAW
IMPORTANT: Read carefully before installing fixture. Retain for future reference.
Use only elements provided by Iris® Lighting Systems. Use of other manufacturers reflectors Voids the
Underwriters Laboratories listing and CSA certification and could constitute a fire hazard.
INSTALLATION
General Installation for All Elements
Specific instructions for individual elements listed
below.
Remove cardboard overspray protector.
● ●
Elements are installed via two torsion springs.
● ●
Torsion springs fits into the "C" shaped brackets on
the horizontal spin disc located in the platform.
Optical elements are keyed to provide proper
● ●
orientation of optics. A single dropped finger will fit
into a notch on the element to allow it to pull tight to
ceiling. If flange does not seat properly against the
ceiling, rotated it 180° and insert again.
Reflector
Retention Spring
Figure 1.
WARNING
Torsion
Springs
Keyway
White or Raw Die cast flange may be removed for field
● ●
painting. To remove pull off three metal spring clips
that retain reflector from behind flange. (Figure 2.)
Reflector will lift off die cast flange ring. Die cast can
now be painted. To replace reflector, align finger on
reflector's lower lip into notch on die cast. Seat reflector
and replace push on metal spring clips. See diagram for
proper location of springs. (Figure 3.)
Reflector
Retention Spring
Gasket
Side View
Figure 2.
Location of Reflector
Retention Springs
Torsion
Springs
Figure 3.
TM
INS #
Reflector
Keyway for
Reflector
Plan View