Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Prepare the Collar
In order to test the system you will need to use the collar. Your collar comes installed with short contact
points. If your pet has long or thick hair, use the long contact points instead. Tighten or switch the
contact points by using the test light tool (7A).
Turn the Collar On
To turn on the collar, press and hold the mode button for 1 second (7B). The light will turn on, followed by
a series of red flashes which represent the static stimulation level.
Set the Static Stimulation Level
The static stimulation levels increase in strength from 2 to 6, with level 1 being tone-only plus vibration
(no static stimulation), and level 6 being the maximum setting.
1. Press and hold the mode button (7B) until the collar illuminates a red light.
2. The collar will then emit a series of red flashes representing the static stimulation level
(e.g., 4 red flashes means level 4).
3. Increase the static stimulation level by pressing and holding the mode button for 1 second after each series
of flashes.
4. Set the static stimulation level to 6 to prepare for the next step (setting the boundary zone).
Note: Once you count 6 red flashes you are at level 6, and an additional hold will cycle the collar back to
level 1, which is tone-only plus vibration.
Turn the Collar Off
To turn off the collar, press and hold the mode button continuously for 5 seconds (7B). The red light will then turn off. To extend the time
between charging the collar, consider turning it off when not in use.
Static Stimulation Level Table
Level
Indicator Light
1
1 red flash
2
2 red flashes
3
3 red flashes
4
4 red flashes
5
5 red flashes
6
6 red flashes
12
Static Stimulation Level
None—tone-only plus vibration
Low
Low
Medium
Medium-high
High
Additional Collar Features
The Anti Linger feature keeps your dog from staying in the warning
zone and draining the collar battery. If your dog does not return to the
pet area after 2 seconds, he will receive a continuous static stimulation.
This system includes a unique Run Through Prevention feature that
increases the level of static stimulation as your dog approaches the
boundary wire.
In the event that your pet "freezes" in the static stimulation zone,
the Over Correction Protection feature limits the length of static
stimulation to 15 seconds. The collar then remains locked out until your
pet leaves the static stimulation zone.
7A
7B
Publicité
Table des Matières
