Free Spirit In-Ground Fence FS-FENCE-17 Mode D'emploi page 10

Splicing Guide
Your In-Ground Fence system comes with 2 gel-filled splice capsules to ensure that your splices are waterproof.
™
a. Strip approximately 1 cm of insulation off the ends of the wires to be spliced (5C).
b. Insert the stripped ends into the wire nut and twist the wire nut. Make sure there is no copper exposed beyond the end of the
wire nut.
c. Tie a knot 7.5 cm - 10 cm from the wire nut (5D). Ensure that the wire nut is secure on the wire splice.
d. Once you have securely spliced the wires together, open the lid of the gel-filled splice capsule and insert the wire nut as deeply as
possible into the waterproof gel inside the capsule (5E).
e. Snap the lid of the capsule shut (5F).
5C
1 cm 1 cm
1
10
5D 5E 5F