Cleaning, Maintenance And Ordering Of Spare Parts; Disposal And Recycling - EINHELL BT-VC 500 Mode D'emploi D'origine

Anleitung_BT_VC_500_SPK7:_
GB
7. Cleaning, maintenance and ordering
of spare parts
Important!
Always pull out the mains power plug before starting
any cleaning work.
7.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
We recommend that you clean the appliance
immediately after you use it.
7.2 Cleaning the appliance head (3)
Clean the appliance regularly with a damp cloth and
some soft soap. Do not use cleaning agents or
solvents; these may be aggressive to the plastic parts
in the appliance.
7.3 Cleaning the container (7)
The container can be cleaned with a damp cloth and
some soft soap or under running water, depending on
the amount of dirt.
7.4 Cleaning the filter (4/11/12)
The foam filter (12) can be cleaned with soft soap and
running water and dried in the air. The filter cage (4)
and the filter cartridge for fine ash dust (11) can be
cleaned by blowing compressed air at low pressure.
7.5 Servicing
At regular intervals and before each use, check that
the filters in the ash vacuum are securely fitted.
7.6. Ordering spare parts
Please provide the following information on all orders
for spare parts:
Model/type of the appliance
Article number of the appliance
ID number of the appliance
Part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info

8. Disposal and recycling

The appliance is supplied in packaging to prevent its
being damaged in transit. This packaging is raw
material and can therefore be reused or can be
returned to the raw material system. The appliance
and its accessories are made of various types of
material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
10
20.05.2009 16:39 Uhr Seite 10