Operation And Maintenance; Tips And Recommendations For Use - Simu T5ZSP Notice Originale

5.2. Re-adjustment of down end limit:
1 2
>>
6 s max.
6 s
1. Position the product on the down end limit set in §2.3 using the ▼ key.
2. Press the ▼ key 6 times, each time for 6 seconds. After the 2nd, 3rd, 4th, 5th, and 6th press the motor
rotates briefly one way, then in the other*.
3. Position the product on the new desired down position using the ▲ and ▼ keys.
4. To confirm the new end limit position, press ▲ twice:
- once for 0,5 s without the motor rotation
- and the second time for at least 3 seconds, so the motor rotates briefly one way and then in the
other*.
The settings are now completed.
* Press the buttons until the motor turns into the two directions.
CANCELLING OF END LIMIT ADJUSTMENTS
6
- Connect the motor to the settings switch (§2.1)
- Press the ▲ and ▼ keys simultaneously, for at least 7 seconds. The
motor rotates one way, then in the other*, then a few seconds later
rotates in both directions. After this operation, the motor returns to
its factory settings, repeat the operations from chapter 2.
* Press the buttons until the motor turns into the two directions.

OPERATION AND MAINTENANCE

7
- This drive is maintenance-free.
- Press the ▲ button on the control point to raise the product.
- Press the ▼ button on the control point to lower the product.

Tips and recommendations for use:

OBSERVATIONS
The motorised product does not
operate.
If the motorised product still does not work, contact a drive and home automation professional.
We care about our environment. Do not dispose of the appliance with usual household waste. Give
it to an approved collection point for recycling.
SIMU SAS, F-70103 GRAY as manufacturer hereby declares that the drive covered by these instructions when marked
for input voltage 230V~50Hz and used as intended according to these instructions, is in compliance with the essential
requirements of the applicable European Directives and in particular of the Machinery Directive 2006/42/EC and
EMC Directive 2014/30/EU. The full text of the EU declaration of conformity is available at www.simu.com. Fabrice
GLORIEUX, general director, GRAY, 04/2018
EN
5/5
>> >>
6 s max. 6 s max.
6 s 6 s
POSSIBLES CAUSES
The drive is in thermal protection.
>> >>
6 s max. 6 s max.
6 s 6 s
4
3
>>
0.5 s
6 s
>>
> 7 s
2 s
7 s
SOLUTIONS
Wait until the motor cools down.
+
6 s max.
>3 s