Symbols; Features - Ryobi SUPERCHARGER P125 Manuel D'utilisation

Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper
interpretation of these symbols will allow you to operate the product better and safer.
SYMBOL
V Volts
A Amperes
Hz Hertz
W Watt
min Minutes
Alternating Current
Direct Current
n o
No Load Speed
.../min Per Minute
Wet Conditions Alert
Read The Operator's Manual
Eye Protection
Safety Alert
PRODUCT SPECIFICATIONS
Battery Pack Voltage ..............................................................................................................................................18 Volt DC
Charger Input........................................................................................................................................ 120 V, AC only, 60 Hz
KNOW YOUR CHARGER
See Figure 1, page 8
The safe use of this product requires an understanding of the
information on the product and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
DIAGNOSTIC FEEDBACK
LEDs provide feedback to indicate whether the battery pack
is charging, fully charged, or defective.

SYMBOLS

NAME
Voltage
Current
Frequency (cycles per second)
Power
Time
Type of current
Type or a characteristic of current
Rotational speed, at no load
Revolutions, strokes, surface speed, orbits etc., per minute
Do not expose to rain or use in damp locations.
To reduce the risk of injury, user must read and understand
operator's manual before using this product.
Always wear safety goggles or safety glasses with side shields and,
as necessary, a full face shield when operating this product.
Precautions that involve your safety.

FEATURES

4 — English
DESIGNATION/EXPLANATION
DUAL CHARGE
The battery charger can charge either lithium-ion or nickel-
cadmium batteries.
WALL MOUNT BRACKET
The charger comes with a space-saving wall mount bracket
for quick and easy storage. Screws should be installed so
that the center distance is 15 in.
KEY HOLE HANGER
The charger has a key hole hanging feature for convenient,
space saving storage. Screws should be installed so that
the center distance is 8-3/4 in.