Installation Guide - Reflexion Lift 2.0 Manuel Du Propriétaire

installation guide

STEP 1
Place the bed base box in a desired location with the bottom of
the box facing up.
Remove the binding straps and packing materials, making sure
not to puncture the box with any sharp objects.
STEP 2
Remove the bed base from the box. Unfold the bed making
sure to keep the bottom of the bed facing upwards.
STEP 3
To install Headboard Brackets (sold separately)
see instructions on page 11.
Legs are shipped fully assembled. To install the legs, thread the
leg into frame, and tighten by hand. Do not over tighten.
6
Always use two people when setting up the base.
For customer support, call Customer Service: 1-800-268-4414
STEP 4
To sync two bases see detailed installation
instructions on pages 9-10.
It is recommended to leave the battery
backup strap attached to the power supply
for use when needed. 2 9V batteries (not
included) will be required for its use.
STEP 5
Uncoil input Power Cord (connected to
motor) and plug into Power Supply.
STEP 6
Uncoil the Power Cord and connect to the
Power Supply. Place Power Supply on the
ground and extend from the base. Ensure
that the Power Supply and all attached
cords are directed toward the desired
surge protector.