Syncing Two Bases - Reflexion Lift 2.0 Manuel Du Propriétaire

syncing two bases (optional)
You can sync two bases in a split setup to operate simultaneously.
Please note, only one remote can control both beds. Dual remote operation is not possible.
STEP 1
Unplug bases from power source.
STEP 2
Disconnect the Head Motor cable and the remote from splitter
cable on one of the bases. Set remote aside, it will not be used.
Splitter Cable
STEP 3
Connect the head motor to the splitter cable on the other base
(refer to illustration at right).
10
Head Motor
STEP 4
Plug bases back into the power source.
STEP 5
Check to ensure all cords are securely attached. Remote will
now operate both bases simultaneously.
PERFORMANCE NOTES
If bases become mismatched, lower bases to flat position to
sync the mechanical positions.
The system is now linked. Buttons pressed on either remote
will control both bases simultaneously.
Remote
Power Supply
Power Cord
Splitter Cable
Head Motor
Remote
Power Supply
Power Cord
Splitter Cable
Head Motor