Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Select Location
The proper location will ensure peak performance
of your refrigerator. We recommend a location
where the unit will be out of direct sunlight and
away from heat sources. To ensure your product
performs to specifications, the recommended
installation location temperature range is from 55 to
100°F (13 to 38°C) for indoor units and 55 to 115°F
(13 to 46°C) for outdoor units.
Cabinet Clearance
Ventilation is required from the bottom front of the
refrigerator. Keep this area open and clear of any
obstructions. Adjacent cabinets and counter top
can be installed around the refrigerator as long as
the front grille remains unobstructed.
WARNING
!
An optional stacking kit, for 24" wide models,
is required to stack products. Failure to use a
stacking kit could result in personal injury. Con-
tact your dealer or Northland customer service
at 844-875-7064 to order.
CAUTION
!
Front Grille
Do not obstruct the front grille. The openings within
the front grille allow air to flow through the con-
denser heat exchanger. Restrictions to this air flow
will result in increased energy usage and loss of
cooling capacity. For this reason it is important this
area not be obstructed and the grille openings kept
clean. Northland does not recommend the use of
a custom made grille as air flow may be restricted.
(See Figure 2).
INSTALLING YOUR REFRIGERATOR
Front Leveling
Legs
Leveling Legs
Adjustable legs at the front and rear corners of
the appliance should be set so the unit is firmly
positioned on the floor and level from side to side
and front to back. The overall height of your Marvel
appliance may be adjusted higher (by turning the
leveling leg out, CCW) and lower (by turning the
leveling leg in, CW) dimensions as shown in Table
"A".
To adjust the leveling legs, place the appliance on a
solid surface and protect the floor beneath the legs
to avoid scratching the floor. With the assistance of
another person, lean the appliance back to access
the front leveling legs. Raise or lower the legs to
the required dimension by turning the legs. Repeat
this process for the rear by tilting the appliance
forward using caution. On a level surface check the
appliance for levelness and adjust accordingly.
The front grille screws may be loosened and the
grille adjusted to the desired height. When adjust-
ment is complete tighten the two front grille screws.
(See Figure 5).
Model
Door Style
MP24*
(S)
MP24*
(P)
4
Front Grille, keep
this area open.
Rear
Leveling
Legs
Figure 2
Minimum
Maximum
Height
Height
34"
35"
(86.4 cm)
(88.9 cm)
34"
35"
(86.4 cm)
(88.9 cm)
Table A
Publicité
Chapitres
Table des Matières
Dépannage
