AGA marvel MP24FAS4 Série Instructions D'installation, D'utilisation Et D'entretien page 17

OVERLAY DOOR PANEL INSTALLATION
BRASS EXTENSION
SPRING WASHER
NUT
LOCK
1/2 HOLE
13/16 COUNTER
BORE 7/16 DEEP
3/4 INCH
WOOD PANEL
Figure 19
Step 6: Install lock cam
Attach the lock cam to the back of the lock assem-
bly with the phillips head screw provided. Orient the
lock cam vertically when installing on the lock.
Spring
washer
Retainer
nut
Lock
Key
CAM
PHILLIPS SCREW
INNER
DOOR
SECTION A-A
SCALE 1 : 1
#8 x 3⁄4" black
screws
(3 places)
Cam
Cam stop Set screw
washer
Figure 20
Step 7: Install the door
Carefully open the top and bottom hinges on the
door being careful as there are many pinch points.
Place the hinges over the 4 screws in the cabinet,
2 at the top and 2 at the bottom and slide the door
into position. Tighten the 4 hinge screws with a
phillips screwdriver. (See Figures 11 and 11a).
Place wire harness from the grille and mount to the
bottom of the door with the screw and "P" clamp
removed in step 1. (See Figure 11b). Reconnect the
wire harness, (See Figure 12).
Step 8: Secure the cabinet
3
Use the #8 x ⁄ " black screws from the literature
4
pack to secure the counter top to the cabinet top
through the holes in the cabinet "Z" bracket.
Screw
Brass extension
(2 lengths provided
17
Cabinet
"Z" bracket
Figure 21