Description Of The Terminal's Keys; Start-Up Of The Terminal - Important Information; Setting Up The Headset; Description Of The Configurator - Vokkero Squadra Mode D'emploi

209920A VOKKERO SQUADRA 8 CEE REFERES - Mode d'emploi / User guide version V1.1.1

1.3. Description of the terminal's keys

On/Off
Allows powering up, or shu-
tdown of the terminal.
+/-
Allows direct access to
volume control or channel
selection. In the setup
menu of the device can
adjust the settings.
1.4. Start-up of the terminal – Important information
Before starting up your terminal, make sure that it has been properly charged using the
dedicated charger.
• To switch on the device, press the On/Off key and keep pressing it until it starts up, and
then release the key.
• To switch off the device, press the On/Off key and keep pressing it until it is turned off.
Note 1: All the parameters, including the volume setting, are retained when you switch off the device and they remain
the same when you switch the device back on.
Note 2: The terminal automatically places itself in the power-saving mode after a few seconds if it is not being used.
This mechanism places the terminal's LCD screen on stand-by. To wake up the LCD screen, press any key on the
terminal.

1.5. Setting up the headset

The headset supplied with the Vokkero® Squadra kit
must be connected the socket located at the base of the
terminal. Check that the connector is well installed in the
housing and secure the connexion by pushing strongly on
the connector. A poor connection may cause audio quality
problems, or the impossibility to hear and / or listen.
2.

Description of the configurator

The configurator does not have a connector enabling it to be powered directly, and it does not have an On/Off switch
either. To start it up, the configurator must be connected to one or more chargers. These must be powered from the
mains via the specific power supply unit supplied with the Vokkero® Squadra kit. The configurator is equipped with a
USB socket for updates, as well as a stylus which enables the touch screen to be used.
When the system is started up, the configurator displays the Vokkero logo, and then the home screen.
+/-
Allows direct access to
volume control or channel
selection. In the setup
menu of the device can
adjust the settings.
Page
EN
31 of 54