Jung FM ST 50 UP Instructions D'utilisation page 9

eNet
Récepteur variateur 1-10 V
Switch­off warning
Priority, lock­out protection
Priority, restraint
Priority, wind alarm
Priority, sun protection
Priority, twilight
Switch off brightness over­
shoot
82581013
J:0082581013
On, Off
Basic setting: Off
0...4
Basic setting: 1
0...4
Basic setting: 2
0...4
Basic setting: 3
0...4
Basic setting: 0
0...4
Basic setting: 0
On, Off
Basic setting: On
9/11
If the switch­off warning is ac­
tive, then, during switch­off,
the systems dims to minimum
brightness within 30 seconds
and only then switches off. If
the parameter "Dim down
ramp" is configured as longer
than 30 s, then the length of
the dim down ramp is applied.
If, during the dim down opera­
tion, another command is gi­
ven, e.g. switch on or scene
recall, then the switch­off war­
ning stops and the command
is executed. A switch­off com­
mand restarts the time for the
switch­off warning.
Note: The set time apply to
operation using radio transmit­
ters. The device is switched
immediately when the Prog
button is pressed.
Specifies the priority for recal­
ling and removing a scene of
type Lock­out protection for
the channel.
Note: 1 is the highest priority
and 4 the lowest. 0 means no
priority.
Specifies the priority for recal­
ling and removing a scene of
type Forced position for the
channel.
Specifies the priority for recal­
ling and removing a scene of
type Wind alarm for the chan­
nel.
Specifies the priority for recal­
ling and removing a scene of
type Sun protection for the
channel.
Specifies the priority for recal­
ling and removing a scene of
type Twilight for the channel.
Allows automatic switch­off
according to the brightness. If
the parameter is On, then the
light controller switches off au­
tomatically when the bright­
ness setpoint is greatly excee­
ded.
Note: This parameter is not
yet active, as a light controller
has not yet been implemen­
ted.
13.03.2014