Jung FM ST 50 UP Instructions D'utilisation page 7

eNet
Récepteur variateur 1-10 V
Manual switch­off of the run­
on time
Switch­on brightness
Switch­on delay
Switch­off delay
Dim up ramp
82581013
J:0082581013
On, Off
Basic setting: Off
1...100 %
Basic setting: 100 %
0 s ... 24 h
Basic setting: 0 s
0 s ... 24 h
Basic setting: 0 s
0 s ... 24 h
Basic setting: 0 s
7/11
Allows manual switch­off of a
running run­on time. If the pa­
rameter is switched off, then a
switch­off command will also
switch the actuator on. This
parameter is directly connec­
ted to the "Run­on time" para­
meter.
During brief operation, the out­
put switches on at the set
switch­on brightness.
Note: If the value is above the
set maximum brightness or
below the minimum bright­
ness, then the system will
switch to the appropriate limit
value.
The load switches on after a
delay. Repeated switch­on
commands restart the delay
time. If the load has not yet
been switched on due to the
delay when a switch­off com­
mand comes, then the load
will remain off.
Note: The set time apply to
operation using radio transmit­
ters. The device is switched
immediately when the Prog
button is pressed.
The load switches off after a
delay. Repeated switch­off
commands restart the delay
time. If the load has not yet
been switched off due to the
delay when a switch­on com­
mand comes, then the load
will remain on.
Note: The set time apply to
operation using radio transmit­
ters. The device is switched
immediately when the Prog
button is pressed.
Time between switch­on and
reaching switch­on brightness.
The light is switched on at mi­
nimum brightness and then
dimmed to the switch­on
brightness.
Only applies to switch­on with
transmitters (short operation).
If scenes are recalled or swit­
ching uses logic modules, the
switch­on brightness is ap­
proached using so­called soft
dimming (not configurable).
13.03.2014