Jung FM ST 50 UP Instructions D'utilisation page 8

eNet
Récepteur variateur 1-10 V
Dim down ramp
Dimming adjustment time
Run­on time
Behaviour after the end of the
disabling function
Behaviour on voltage return
Brightness on voltage return
82581013
J:0082581013
0 s ... 24 h
Basic setting: 0 s
1...60 s
Basic setting: 4 s
0 s ... 24 h
Basic setting: 0 s
On
Off
no change
Last value
Basic setting: No change
On
Off
Last value
Configured brightness
Basic setting: Off
0...100 %
Basic setting: 100 %
8/11
Time until reaching minimum
brightness. The light is dim­
med to minimum brightness
and then switched off.
Only applies to switch­off with
transmitters (short operation).
If scenes are recalled or swit­
ching uses logic modules, the
system switches off directly.
Time from minimum bright­
ness until reaching maximum
brightness (dimming speed).
As soon as a run­on time has
been entered, the actuator will
no longer remain on perma­
nently, but only for the length
of the run­on time. The run­on
time is restarted if actuation is
repeated. This parameter is di­
rectly connected to the "Ma­
nual switch­off of run­on time"
parameter.
Note: The set time apply to
operation using radio transmit­
ters. The device is switched
immediately when the Prog
button is pressed.
Behaviour of the output when
a block is removed.
Defines the behaviour of the
output after voltage return.
Brightness value, set by the
output after voltage return
(mains voltage). The parame­
ter "Behaviour after voltage re­
turn" must be set to "Configu­
red brightness".
Note: If the value is above the
set maximum brightness or
below the minimum bright­
ness, then the system will
switch to the appropriate limit
value.
13.03.2014