E.zicom E.ziclean FURTIV Manuel Utilisateur page 24

E.ziclean FURTIV by E.ZICOM
Manuel Utilisateur – User Manual
6. Assembly & Disassembly and Cleaning of Main Brush ,Floor
Brush, Side Brush:
a. Assembly & Disassembly of Mid
Cleaning Brush and Floor Brush:
Force the locking bar forward and raise the
cover by right thumb, and then raise rod of
the mid cleaning brush by your left hand.
(Refer to Figure 1 and Figure 2)
Take out the main brush and floor brush.
(Refer to Figure 3)
Insert the main brush and floor brush into
the holes before closing the cover in
assembly.
b. Assembly & Disassembly of Side
Brush:
Release the screw in the main shaft of the
side brush before changing the side brush.
Press the side brush against the main shaft
and then fasten the screw. (Refer to the
figure)
c. Cleaning of Main Brush and Floor
Brush:
Clear the hair or big dust particles on the
brush and floor brush regularly to improve
the cleaning performance. Clean the dust at
the air intake. Clean the wastepaper or
small particles by dust brush directly.
Rotate the brush carefully and cut by
scissors or pull by hand
E.ziclean FURTIV by E.ZICOM
Manuel Utilisateur – User Manual
the hair, yarn and other twisted objects.
The cleaning of the main brush and floor
brush can be done by reference to the
assembly & disassembly.
c. Cleaning of Sensor and Infrared
Transparent Window:
Clean the sensor and infrared transparent
window with the cotton swab or soft cloth.
The wall detection sensor is in front of the
Cleaner, while the ground detection sensor
and infrared transparent window are at the
bottom of the Cleaner. (Refer to the figure
below)
Please keep the transparent window clean
so as to make the Robot work better.