LEAD dynamic PB Série Manuel D'utilisation page 4

ENGLISH
Thank you for choosing a product from LEAD energy
AG. If you would like to get in touch with our service
team, please contact them via our website or by
e-mail.
Intended use
You can install the PB panels in grid ceilings or install
them as surface mounted ceiling lights or suspended
lights using the accessories that are available
separately.
1
Mounting
Note that the WLAN controller for your luminaire
must be accessible for product configuration. You
can also configure your luminaire prior to instal-
lation. The settings will be maintained even if the
power supply is disconnected. Make a note of the
SSID and password of the WLAN controller.
1.2
Mounting in suspended ceilings
Fix the spring clips provided to your panel using the screws. Make a ceiling cut-out; the size of the cut-out can be
selected from the following list:
PB29: 289 x 289 mm
PB59: 589 x 589 mm
PB62: 609 x 609 mm
The cut-out must be extremely precise. The edges of the cut-out must be able to bear the weight of the luminaire.
Connect the power supply in the ceiling. Insert the panel into the cut-out in the ceiling by pressing back the spring
clips. Make sure the panel is locked fully into place.
LEAD energy AG Am Stadtbad 37 45219 Essen-Kettwig
Note
Please observe the warnings prior to installation.
1.1
You can install your PB in grid ceilings by replacing
a ceiling panel with the respective light panel. The
size of the ceiling panel must match that of the light
panel.
PB60: 589 x 289 mm
PB120S: 1189 x 139 mm
PB120: 1189 x 289 mm
Subject to errors and amendments
?
service@lead-energy.com
www.lead-energy.com
Mounting in grid ceilings
Information / Technical support: www.lead-energy.com