Battery Installation; Radio Operation - AudioSonic HF-1253 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 15

BATTERY INSTALLATION

Insert a "Cell" size batteries into the battery compartment. Be sure that the batteries
are inserted damage to the remote control. Always remove the batteries when
the remote control will not be used for a long period of time, as this will cause
leakage to the batteries and subsequently damage to your set.
Slide out cover and install single "Cell" battery with polarities as shown.
Notes:
• Power button on main unit must be 'On' in order for Remote Control to operate.
• If the distance required between the remote control and the appliance decreases,
the batteries are exhausted. In this case replace the batteries with new one.
SENSOR WINDOW OF THE RECEIVER
• Even if the remote control is operated within the effective range, its operation may be
impossible if there are any obstacies between the appliance and the remote control.
• If the remote control is operated near other appliances which generate infrared rays,
or if other remote control devices using infrared rays are used near the appliance,
it may operate incorrectly.
6
Instruction Manual

RADIO OPERATION

General operation
• Set the "FUNCTION" selector to "RADIO" mode.
• Select desired band by using the "BAND" selector.
• Adjust radio frequency to your desired station by using the "TUNING" control.
• Adjust the "VOLUME" control to the desired level.
FM / FM-stereo reception
• Set the "BAND" selector to FM mode for MONO reception.
• Set the "BAND" selector to FM ST. mode for FM STEREO reception.
The Stereo indicator light up to show FM ST. mode.
For better reception
• FM - This appliance has a FM antenna located at the rear cabinet.
This wire is completely unraveled and extended for better reception.
• AM - This appliance is equipped with a built - in directional ferrite AM antenna.
Rotate the appliance to get better reception.
CD / MP3 OPERATION
General operation
PLAY / PAUSE (
)
Press to start playing CD / MP3 disc.
Press again to stop playing CD / MP3
operation temporarily.
Press again to resume playback.
SKIP + & (
)
Press to go to the next track or back to the previous track.
SKIP - (
)
Press and hold while playing until you find the point of
the sound.
STOP ( )
Press to stop all CD / MP3 operation.

Publicité

Table des Matières
loading

Table des Matières