Speakers; How To Connect - Yamaha Rx-V995 Mode D'emploi

PREPARATION

Speakers

Use speakers with the specified impedance shown on the rear of this unit.
Center speaker

How to Connect:

Connect the SPEAKERS terminals to your speakers with the wire of the proper gauge (keep as short as possible). If the
connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct. That is
the + and – markings are observed. If these wires are reversed, the sound will be unnatural and lack bass.
Caution
Do not let the bare speaker wires touch each other or any metal part of this unit. This could damage this unit or the
speakers, or both.
Red: positive (+)
Black: negative (–)
2
1
3
22
Subwoofer system
REMOTE OUTPUT
CONTROL
CENTER REAR
IN OUT
SUB
WOOFER ( SURROUND )
CAUTION
SEE INSTRUCTION MANUAL FOR CORRECT SETTING.
A
OUTPUT
MAIN
B
Right
Main speakers B
Loosen the knob.
Insert the bare wire.
[Remove approx. 5mm
(1/4") insulation from
the speaker wires.]
Tighten the knob and
secure the wire.
Rear speakers
Right
SPEAKERS IMPEDANCE SELECTOR
CENTER REAR
SET BEFORE POWER ON
( SURROUND )
MAIN
A
B
Left
Right
<
Except Singapore model
Banana Plug connections are also possible. Simply insert the
Banana Plug connector into the corresponding terminal.
Left
(U.S.A. model)
CENTER : 4ΩMIN. / SPEAKER
REAR : 6ΩMIN. / SPEAKER
MAIN
A OR B : 4ΩMIN. / SPEAKER
A B : 8ΩMIN. / SPEAKER
CENTER : 8ΩMIN. / SPEAKER
REAR : 8ΩMIN. / SPEAKER
MAIN
A OR B : 8ΩMIN. / SPEAKER
A B :I6ΩMIN. / SPEAKER
Main speakers A
>
Left