Description; Safety - Vortice VORT NOTUS Notice D'emploi Et D'entretien

ENGLISH

Description

Appliances belonging to the VORT NOTUS range are
as follows:
VORT NOTUS
VORT NOTUS T-HCS
These appliances are axial extractor fans that have
been specially designed to provide continuous
ventilation in domestic applications whilst at the same
time reducing power consumption and noise
emissions.
The appliances are compatible with wall and ceiling
mounting and are fitted with axial blades powered by a
brushless motor. There are three differing fan speeds
available. The default minimum speed can be one of
two speeds that can be selected during installation
whereas the third speed can be selected while the
appliance is running (see "Installation").

Safety

• Do not use this appliance for functions other than
those described in this booklet
Warning:
this symbol indicates that care must
be taken to avoid injury to the user
• After removing the appliance from its packaging,
ensure that it is complete and undamaged. If in
doubt contact a professionally qualified electrician or
Vortice. Do not leave packaging within the reach of
children or infirm persons
• Certain fundamental rules must be observed when
using any electrical appliance, including:
- never touch electrical appliances with wet or damp
hands;
- never touch appliances while barefoot;
- never allow children or infirm persons to operate
appliances unattended.
• This appliance is not suitable for use by children or by
individuals with reduced physical, sensorial or mental
capacities, or by inexperienced or untrained
individuals, unless they are supervised or instructed
in its use by a person responsible for their safety
Children must always be supervised to ensure that
they do not play with the appliance.
• Store the appliance out of the reach of children and
less able persons after deciding to disconnect it from
the power supply and use it no more.
• Do not use the appliance where flammable vapours
are present (spirit, insecticides, petrol, etc.).
• Never touch the electronics as some of the
components may still be electrically charged.
•The appliance can also be ceiling mounted. For
ceiling mounting, the IPX4 rated protection against
humidity can be guaranteed by keeping the frontal
panel in position and using the special seal. Be
careful not to ceiling mount the appliance without
first fitting the special seal.
• Do not make modifications of any kind to this
appliance.
Caution:
this symbol indicates that care must
be taken to avoid damaging the appliance
• Do not expose this appliance to the weather (rain,
sun, etc.).
• Regularly inspect the appliance for visible defects. If
the appliance does not function correctly, do not use
it and contact Vortice immediately.
• If the appliance does not function correctly or
develops a fault, contact Vortice immediately and
ensure that only genuine original Vortice spares are
used for any repairs.
• Should the appliance be dropped or suffer a heavy
blow, have it checked immediately by Vortice
• The appliance must be installed by a professionally
qualified electrician
• The mains power supply to which the units are
connected must comply with current laws.
• The appliance is double insulated and therefore
does not need to be earthed
• The electrical power supply/socket to which the
appliance is to be connected must be able to provide
the maximum electrical power required by the
appliance
• Use a suitably sized multi-polar switch with minimum
contact gaps of 3 mm to install the appliance.
• Switch off the appliance at the installation's main
switch: a) if the appliance does not function correctly;
b) before cleaning the outside of the appliance, c) if
the appliance is not to be used for any length of time.
• The appliance cannot be used to control activation
of water heaters, room heaters, etc. and it must not
exhaust into the hot air flues.
• The air to be extracted from the room must be clean
(i.e. free of grease, soot, chemical and corrosive
agents, and explosive or flammable mixtures).
• Do not cover or block appliance intake or outlet vents
grilles as this may prevent optimum air flow.
• VORT NOTUS T-HCS model: do not cover or block
the HCS sensor grille.
• Specifications for the power supply must correspond
to the electrical data on data plate A (Fig.1)
• The power cable must never be replaced/repaired by
the user, but only by a qualified electrician
7