Authorization; Displays And Signals; Authorization Via Rfid - Eaton xChargeIn Manuel D'utilisation

Authorization

5 Authorization
This section covers the RFID authorization feature of
xChargeIn X Series and S Series. For the description of the authorization
function of xChargeIn M Series, see the "Configuration Manual".
xChargeIn X Series and S Series can optionally be equipped with the follow-
ing authorization functions:
●
●
Also, with the enable input X1, it is possible to authorize the charging via ex-
ternal components (e.g., house control, ...). For more information, see the
"Installation Manual".
5.1

Displays and signals

During authorization, the charging station can display different light patterns
on the LED bar and emit acoustic signals.
LED bar
Flashing green
(every 3 seconds)
Flashing blue
(every 3 seconds)
Orange
(S4)
Acoustic signals
Single tone
Rising tone sequence
Falling tone sequence
5.2

Authorization via RFID

By default, a charging process can be started without authorization. In order
to use the authorization via RFID, RFID cards need to be taught-in.
A maximum of 20 RFID cards can be taught into a charging station. An RFID
master card must first be taught-in for this. Using this master card, additional
RFID slave cards can subsequently be taught-in.
114
Authorization via RFID card
Authorization via key switch
Display
Authorization done correctly. / No authorization required.
The charging station is waiting for authorization to enable a
charging process. Authorization necessary, either by key switch,
RFID card or via the enable input X1.
The teach-in of an RFID slave card must be confirmed by hold-
ing the RFID master card in front again.
Signal
Authorization by key is done correctly. / RFID card has been
read.
RFID card has been accepted.
RFID card has been rejected (no authorization).
Description
Description
Operating instructions V1.04
xChargeIn
© EATON