König Electronic SEC-IPCAM100B(W) Mode D'emploi page 5

APPLE
Set the IP camera to connect to the Wi-Fi router
Open up "Settings" on your iOS device and select "Wi-Fi" and let it search for a network.
8
The network will be "Wi-Fi-cam-p2p". Select "Wi-Fi-cam-p2p" to connect.
Now, open the "uCare Cam" app and select the tab at the bottom of the screen that says
9
"Wi-Fi Connect".
Select "Router mode", then "Next". Enter the Wi-Fi router SSID and password for your
10
home router.
After the IP camera receives this information, it will restart. Please wait for it to start up and
11
connect to your Wi-Fi router. When it successfully connects, the status LED colour will turn
orange. It may take up to 5 minutes.
Then select the camera name in the "uCare Cam" app to connect.
Note: If the status LED colour does not turn orange, please check your Wi-Fi router and
12
make sure the IP camera is within the signal area of your Wi-Fi router. Then try this setup
again.
Install your IP camera by WPS connection mode
If your Wi-Fi router has a WPS (Wi-Fi Protected Setup) button, you can use it to set up the IP camera.
(Must enable WPA/WPA2 encryption in Router). On the Wi-Fi router, you will see a button labelled
"WPS". It may also be called "QSS" or "AOSS"
Setup Wi-Fi - WPS mode
1
Open the "uCare Cam" app
and select "Wi-Fi Setting" or "Wi-Fi Connect" at the bottom of the screen.
Select the tab:
then select the tab:
to enter Step 2 (see Figure 8).
Enter WPS mode
2
Power on your IP camera. The status LED on the IP camera will be green for about 15
seconds.
Programme Loading
3
The status LED will flash red for about 15 seconds.
5