König Electronic SEC-IPCAM100B(W) Mode D'emploi page 3

There are two options to continue the easy set up of your IP camera.
Install your IP camera by ROUTER MODE
Power On
Plug the power adapter DC connector into the DC input port of the IP camera and then plug
1
the power adapter into a wall outlet. The status LED on the IP camera will turn green for
about 15 seconds.
Programme Loading
2
The status LED will flash red for about 15 seconds.
Router Link Mode
3
Wait until the status LED colour alternates between red and green.
Note:
If the LED does not turn red and green, then press the WPS/Reset button for more than
10 seconds to restart the IP camera.
When the green status LED lights up and holds, and then the red status LED flashes twice,
after which it changes into green, the IP camera has entered the RESET state. At this
moment you can release the button and then wait until the status LED alternates between
red and green.
ANDROID (for Apple go to: Step 8)
Set the IP camera to connect to the Wi-Fi Router
4
Open the "uCare Cam" App and select:
Click here to install the new Wi-Fi Camera
In the screen of the Camera List Window (see figure 1).
3
Figure 1
"Camera List Window"