Working With The Power Tool - Flex DD 2G 18.0-EC Notice D'instructions Originale

Switching on the power tool
To switch the power tool on:
 Press the trigger switch.
The power tool trigger switch allows the
operator to increase the speed in
increments up to the maximum speed.
To switch the power tool off:
 Release the trigger switch.
NOTE
The power tool is equipped with a brake
–
which stops the cutting accessory as
soon as the trigger switch is released.
When using the power tool continuously,
–
the operator should work primarily with
the trigger switch fully depressed.
Workplace lamp on/off switch
1. Turn direction of rotation preselector
switch (2) to "Forwards" or "Reverse".
2. Press electric tool on/off switch (1)
– Workplace lamp lights up
3. Release electric tool on/off switch (1)
– Workplace lamp goes out
automatically after approx. 10 sec.
Speed and torque preselector switch
IW 1/2" 18.0-EC / ID 1/4" 18.0-EC
26
DD 2G 18.0-EC / PD 2G 18.0-EC / IW 1/2" 18.0-EC / ID 1/4" 18.0-EC
Change speed/torque
1. Activate on/off switch (1)
2. Press mode switch briefly (approx. 0.5 sec.).
– An LED lights up – torque:
IW 1/2" 18.0-EC:
ID 1/4" 18.0-EC:
3. Press mode switch briefly
– Two LEDs light up – torque:
IW 1/2" 18.0-EC:
ID 1/4" 18.0-EC:
4. Press mode switch briefly
– Three LEDs light up – torque:
IW 1/2" 18.0-EC:
ID 1/4" 18.0-EC:
5. Press mode switch briefly
– An LED lights up – torque switches
back to:
IW 1/2" 18.0-EC:
ID 1/4" 18.0-EC:
Torque can be increased again as described.
During reverse operation of the electric tool
– which only has one speed – the LEDs in
the base go out automatically.
Change single impact mode to impact
driver mode
 Press mode switch for approx.
1.5 seconds.
– LED mode indicator lights up – single
impact mode active
– LED mode indicator not lit – impact
driver mode active.

Working with the power tool

CAUTION!
Before carrying out any work on the power
tool, move the direction preselector switch (2)
to the middle position.
150 Nm / 1500 rpm
60 Nm / 1500 rpm
180 Nm / 2000 rpm
105 Nm / 2000 rpm
250 Nm / 2500 rpm
225 Nm / 2500 rpm
150 Nm
60 Nm