Torque Preselection; Speed Preselection - Flex DD 2G 18.0-EC Notice D'instructions Originale

DD 2G 18.0-EC / PD 2G 18.0-EC / IW 1/2" 18.0-EC / ID 1/4" 18.0-EC
Direction preselection
CAUTION!
Change the direction of rotation only when
the power tool is stopped.
 Move the direction preselector switch to
the required position:
– Left: counterclockwise (remove screws,
release screws)
– Right: clockwise (drill, insert screws,
tighten down screws)
– Middle: switch-on interlock (tool change,
when working on the power tool)
Operating mode
(PD 2G 18.0-EC only)
CAUTION!
Change the operating mode only when the
power tool is stopped.
 Move the operating mode turning dial to
the required position.
: Drilling
: Screwing
: Impact drilling

Torque preselection

CAUTION!
Change the torque only when the power tool
is stopped.
 Move the torque setting turning dial to the
required position.
DD 2G 18.0-EC:
1–23: Screwing
: Drilling
NOTE
The safety clutch is deactivated in the
Drilling setting .
PD 2G 18.0-EC:

Speed preselection

CAUTION!
Change the speed only when the power tool
is stopped.
 Move the selector switch to the required
stage:
1: Low speed, high torque
2: High speed, low torque
25