Tool Change; Battery State Of Charge; Inserting/Replacing The Battery - Flex DD 2G 18.0-EC Notice D'instructions Originale

Tool change

CAUTION!
Before carrying out any work on the power
tool, move the direction preselector switch (2)
to the middle position.
IW 1/2" 18.0-EC:
 Push adapter on square drive of impact
driver (1.).
 Insert tool in adapter (2.).
ID 1/4" 18.0-EC:
 Pull tool lock forwards (1.) and press in
the tool all the way (2.).
 Release tool lock.
 To remove the tool, pull tool lock
backwards (3.).

Inserting/replacing the battery

 Press the charged battery into the power
tool until it clicks into place.
24
DD 2G 18.0-EC / PD 2G 18.0-EC / IW 1/2" 18.0-EC / ID 1/4" 18.0-EC
 To remove, press the release button (1.)
and pull out the battery (2.).
CAUTION!
Protect the battery contacts when the
battery is not being used. Loose metal parts
may short-circuit the contacts –
Explosion and fire hazard!

Battery state of charge

 Press the button to check the state of
charge at the state of charge indicator
LEDs.
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.