Instructions For Use; Before Initial Operation - Flex DD 2G 18.0-EC Notice D'instructions Originale

Instructions for use

Before initial operation

 Unpack the power tool and accessories
and check that no parts are missing or
damaged.
 Attach the belt clip and bit holder with
the enclosed fastening screw.
NOTE
The batteries are not fully charged on
delivery. Prior to initial operation, charge
the batteries fully. See "Charger/Charging
process".
Fitting/removing the auxiliary
handle (PD/DD 2G 18.0-EC)
CAUTION!
Use auxiliary handles if these are supplied
with the power tool. The loss of control may
result in injuries.
22
DD 2G 18.0-EC / PD 2G 18.0-EC / IW 1/2" 18.0-EC / ID 1/4" 18.0-EC
Changeable drill chuck BF 18.0-EC
CAUTION!
Before carrying out any work on the power
tool, move the direction preselector switch (2)
to the middle position.
Assemble
 Pull unlocking ring forwards (1.) and
press the drill chuck all the way onto the
tool holder (2.).
 Release unlocking ring. Check that the
drill chuck is locked in position.
Disassemble
 Pull unlocking ring forwards and remove
the drill chuck.
Inserting the tools
Drill bits with a diameter of 1.5–13 mm,
½
" screwdriver bits and
securely held in the drill chuck.
 Grip the power tool firmly with one hand
and turn the chuck with the other hand.
– Turn counterclockwise to open the chuck
further.
– Turn clockwise to close the chuck.
 Insert the tool.
 Close the chuck fully.
NOTE
Carry out a test run to check that the tool is
chucked in the centre.
½
" bit holders are