Safety Instructions - Hama DVB-T Mode D'emploi

G Operating instruction
Thank you for choosing a Hama product.
Take your time and read the following instructions and
information completely. Please keep these instructions in a
safe place for future reference. If you sell the device, please
pass these operating instructions on to the new owner.
1. Package contains:
• 1 antenna
• 1 power supply unit
• 1 current feed switch
• 1 pre-mounted mast mount
• 4 screws for assembly
• 1 coaxial cable with an F connector
and a protective sleeve
• 1 coaxial connector
• 1 adapter, F-plug – coax socket

2. Safety instructions:

• Connect the device only to an electrical socket that has
been approved for the device.
• The mains socket must always be easily accessible.
• Never use or open a defective device.
• Repair work may only be conducted by an authorised
specialist.
• As with all electronic devices, keep the device out of the
reach of children.
3. Intended use:
This active antenna is exclusively suitable for digital TV
reception (DVB-T), digital radio reception (DAB, DAB+) and
analogue TV/radio reception.
4. Equipment
• For mounting indoors and outdoors
• Max. 27dB active amplification
• For digital TV and radio reception (horizontal and vertical)
• Also suitable for analogue TV/radio reception
• Frequency range 85-786 MHz (FM, DAB, DAB+, VHF,
UHF)
• with LTE/GSM Filter to eliminate distortion, caused by
mobile phones
• Suitable for mounting on masts and walls
• Power (+ 5V) can be supplied via the antenna cable from
the DVB-T receiver
• Incl. separate power supply unit and 5.5m antenna
connection cable
• Housing colour: white/grey
2
5. Mounting to antenna mast
Attach the mast mount to the antenna using the four
screws supplied with the unit.
The use of other screws may damage the antenna.
Mount the complete antenna to the mast.
6. Mounting using the wall mount
Remove the metal bar and the clamp of the mast mount.
Attach the mast mount to the wall.
Use screws and rawl plugs suitable for your masonry.
Attach the mast mount to the antenna using the four
screws supplied with the unit. The use of other screws may
damage the antenna.
Note: Before you start to mount the antenna to the wall,
please select a suitable mounting place which guarantees
optimal reception.
7. Orientation
This DVB-T antenna is designed such that both horizontally
and vertically transmitted channels can be received.
The antenna must be pointed towards the transmitter
horizontally or vertically depending on the signal strength
and signal direction.