Installation - Kenwood KOS-A200 Mode D'emploi

Installation

Installation for Remote control
sensor
1
Wipe off the installation location with a cleaning
cloth.
2
Secure the Remote control sensor (Accessory
2) in the specified place with the double-sided
adhesive tape.
• Install the Remote control sensor on a flat surface. If
it is installed on a curved surface, the tape adhesion
may weaken and the controller may come off.
• Do not install the Remote control sensor in places
(such as on the dashboard) where it is exposed to
direct sunlight and the temperature becomes high.
Otherwise, the Remote control sensor will become
deformed and unusable.
• Install the Remote control sensor in places that do
not obstruct driving. Install the Remote control sensor
temporarily and verify that the handle, shift knob, and
side brake can be operated smoothly.
Double-sided
adhesive tape
Installation for FM modulator Unit
• Installation using the self-tapping screws
Use screws (Accessory4) to fix FM modulator Unit
onto an audio board or another.
Accessory4
• Installation using the velcro tapes
Remove the backing from the Velcro strips
(Accessory9) and attach it to the bottom of the
FM modulator Unit. Install the FM modulator Unit
on the carpet.
Accessory9
23
|
English