Accessories/ Installation Procedure - Kenwood KOS-A200 Mode D'emploi

Accessories/ Installation Procedure

Accessories
1
2
3
4
(Ø4 × 16 mm)
5
(Ø3 × 6 mm)
6
7
8
9
22
|
English
Installation Procedure
1. To prevent a short circuit, remove the key from
the ignition and disconnect the - battery.
2. Make the proper input and output wire
connections for each unit.
..........1
3. Connect the wiring harness wires in the
following order: ground, battery, ignition.
4. Connect the wiring harness connector to the
unit.
5. Install the unit in your car.
6. Reconnect the - battery.
..........1
• Only use antenna conversion adapters (ISO-JASO) when
the antenna cord has an ISO plug.
• If your vehicle's ignition does not have an ACC position,
or if the ignition wire is connected to a power source
..........1
with constant voltage such as a battery wire, the power
will not be linked with the ignition (i.e., it will not turn on
and off along with the ignition). If you want to link the
unit's power with the ignition, connect the ignition wire
to a power source that can be turned on and off with the
ignition key.
..........2
• If the fuse blows, first make sure that the wires have not
caused a short circuit, then replace the old fuse with one
with the same rating.
• Insulate unconnected wires with vinyl tape or other
similar material. To prevent short circuits, also do not
..........1
remove the caps on the ends of the unconnected wires
or the terminals.
• After the unit is installed, check whether the brake lamps,
indicators, wipers, etc. on the car are working properly.
..........1
..........1
..........1
..........2