Ryobi RYAC490 Manuel D'utilisation page 8

Some of the following symbols may be used on this tool. Please study them and learn their meaning. Proper interpreta-
tion of these symbols will allow you to operate the tool better and safer.
SYMBOL
Proper Loading
Improper Loading
Improper Log Type
Operator Zone/Correct
Operating Position
Incorrect Operating Position
V Volts
A Amperes
Hz Hertz
Alternating Current
Class II Construction
SYMBOLS
NAME
Only place dry logs flat and lengthwise in the direction of the grain
on the work table. Only attempt to split one log at a time.
Never attempt to split a wet log or a log that is not placed flat
and lengthwise on the worktable. Neither end should be off of
the work table on the ram or wedge. Never attempt to split more
than one log at a time.
Only split dry, cylindrically shaped logs that are cut squarely on
each end. Never attempt to split wet logs or logs that are curved
or are cut at angles on either end.
Always be positioned in the right rear area as facing the log split-
ter controls.
Never stand or kneel directly behind the ram when operating.
Voltage
Current
Frequency (cycles per second)
Type of current
Double-insulated construction
6 — English
DESIGNATION/EXPLANATION