Cleaning And Maintenance; Air Filter - Trudell Medical International OMBRA Manuel De L'utilisateur

7. In a relaxed, comfortably seated position, pick the nebulizer up out of the
and start your treatment.
8. When your treatment is complete or during a rest in your treatment, the nebulizer may be placed back in the
HOLDER and the compressor switched off.
NOTE: The compressor should be unplugged when not in use.

CLEANING AND MAINTENANCE

AIR FILTER

Your Ombra* Table Top Compressor is equipped with a special air filter that will slowly change colour with use. The
original filter is bright white, but it will slowly turn grey with use. Your air filter should be changed every 30 days, or as
visual inspection indicates. The compressor should never be used without an air filter installed.
To change the filter (Figure 5)
AIR FILTER COVER
1. Remove
the cap and filter cover out.
2. Remove filter from the cover, and dispose of the old filter.
3. Insert a new filter into the cover, then place the
approximately 90 degrees to tighten.
4. Do not over tighten. There will be resistance when the AIR FILTER COVER
FIGURE 5
90˚
CAUTION: Do not wash or reuse the filter. Use only Ombra* Replacement Filters (Part Number: 10554493050).
Do not attempt to substitute any other material to act as a filter as this will result in damage to the compressor and may
void your warranty.
NEBULIZER
OWNER'S MANUAL
Refer to the
properly clean your nebulizer.
EZ TWIST TUBING
Occasionally you may notice condensation on the inside of your oxygen tubing. This is normal. To remove the
condensation, simply connect one end of the EZ Twist
compressor to run without the nebulizer attached. This will force air through the tubing, drying the inside. To clean the
exterior, wipe with a damp cloth. Ensure the tubing is dry prior to storage.
COMPRESSOR
Prior to cleaning the compressor, ensure the unit is unplugged from the electrical outlet. Use a damp cloth to wipe the
exterior of the compressor housing. Never use liquid or spray cleaners directly on the compressor. Do not immerse the
power cord or unit in water or another liquid.
CAUTION: Liquids can cause damage to the electrical components inside your compressor and lead to malfunction.
In the event any liquid enters the unit, please contact your Ombra* Authorized Distributor. Do not use the compressor
until it has been inspected, even if it appears to be functioning properly.
EN 6
by holding the cover and turning counterclockwise approximately 90 degrees. Pull
AIR FILTER COVER
included with your reusable AEROECLIPSE* XL BAN for instructions on how to
TUBING
CUP HOLDER. Switch on the compressor
back into the compressor and turn clockwise
is securely fastened.
AIR OUTLET
to the on the compressor and allow the
CUP
90˚