Ir Remote Controller - Avtek USB 3.0 PTZ Guide De Démarrage Rapide

IR REMOTE CONTROLLER

POWER
Under normal working mode, short press POWER key, the camera will enter standby
mode;
Press it again, the camera will do self-configuration, then go back to HOME position.
It will go to preset position if power on mode has been set before.
FREEZE
Short press FREEZE key to freeze/ unfreeze the image.( not work for USB3.0 camera)
IRT (IR Transfer/IR Pass)
Open or close the IR pass function. Once press the IRT key, the camera will receive and
pass the IR remote control signal to the codec/terminal(via VISCA IN port).
SET 1~SET4 ADDRESS SETTING
Long press for 3seconds until the key light ON, to set camera address.
CAM1~CAM4（CAMERA SELECTING）
Short press to select the relative camera.
NUMBER KEY (1-9)
Set preset: long press(3 seconds) the number key to set preset.
Run preset: Short press the number key to run preset.
CLR PRE (CLEAR PRESET)
CLR PRE+ number key: to clear the relative preset.
Long press to clear all preset.
LEARN
Reserved, for factory debugging use.
8