Operation; Operation Instructions - HOLZMANN MASCHINEN SB 3116RHN Mode D'emploi

OPERATION

Device to be operated in a perfect state only. Inspect the device visually every time it is to be
used. Check in particular the safety equipment, electrical controls, electric cables and screwed
connection for damage and if tightened properly. Replace any damaged parts before operating
the device.
13.1

Operation instructions

Perform all machine settings with the machine being
disconnected from the power supply!
Do not attempt to drill material with the surface other than flat unless a
suitable support is available!
Never switch the machine on while pressing the drill bit against the
material!
Before switching the machine on, make sure that the table-

Make sure that the bit is firmly clamped in the chuck

 Due to the height of its own weight is the fixation of the drill press
 Before switching the machine on, make sure that the chuck key is
Use a clip or clamping jaws to secure the piece to be drilled on the

Set the drill to speed answering a specific job

 Check the V-belts and tighten if necessary
In advanced wear of, replace V-belt

 V-belts and pulleys may not come into contact with grease, oil or
Loosen the V-belt for a long break

After drilling movement the sleeve up to the highest position to turn back by hand. Not simply
leaving out the rotating lever. In order to protect the return spring and a long life. You can modify
the tension of the return spring by removing the cover and move the spiral spring. The coil spring
is located on the rotary lever, on the opposite side of the machine.
HOLZMANN MASCHINEN GmbH
W A R N I N G
clamping lever is firmly tightened
to the ground requirement for less-vibration work.
removed
table
other lubricants
www.holzmann-maschinen.at
A T T E N T I O N
N O T I C E
OPERATION
44
SB 3116RHN / SB 3116RMN