Casselin CLV35 Mode D'emploi page 22

Instruction for use
Place the basket in the tank, close the door. The cycle length can be noticed on the data
sheet. For the model without automatic detergent dosing device, pour the recommended dose
of industrial no-foam detergent into the tank. If using powdered detergent we recommend
pouring regularly into the tank not in the same place. The powder must be an industrial foam
power. Press « Start » button (A-2). Wash cycle indicator light (A-6) comes on and the
appliance performs a full wash cycle. When indicator light (A-6) goes off, the wash cycle is
completed. Remove the basket from the appliance and expose it to the air to dry for a few
seconds. When the machine is running, don't open the door. Always use protective gloves.
Conseil pour le lavage
Place cups and glasses upside down in the baskets (5B). The appliance is equipped with
different types of basket, specially designed for stocking that can stack. Place the dessert
plates in the special basket with supports, making sure that the plate face upwards. Place
cutlery and coffee spoons with their handles facing down. Never place silverware and stainless
steel that can be corroded. To save on detergent and electricity only wash when the baskets
are full, but do not overload them. Do not stack dishes. WE RECOMMEND PRE CLIEANING
THE DISHES IN ORDER TO MINIMISE MAINTENACE. The quality of final wash results will
be greatly improved by first removing food particles, lemon peels, toothpicks, olive pits,etc...
which could partially clog the tank filter and impair washing efficiency. We recommend washing
the dishes before food particles dry on their surface. It is good practice, when dried food
scraps are involved, to first soak the dishes in soapy water before introducing them into the
machine.
Drain pump (optional)
Let the line button (A1) on position I. Take the overflow pipe (C2) off the drain hole. Leave the
drain filter (C4) in position and the door opened. Push the drain pump button A3 and keep it
pushed until the tank is completely empty. Release the drain pump button and switch the
machine off pushing on the line button A1 on position O. Now it is possible to close the door. If
the current is not switched off using the line button, when closing the door the tank will start
filling again automatically.
Regeneration
Only for appliances equipped with this accessories.
Let the machine drain completely removing the overflow C2. Press the main button A1 on O
position. Remove the wash pump filter and pour 250g of coarse kitchen salt in the salt
container D10. Press start regeneration button A2 for a few seconds until cycle indicator light
A6 remains lilt. After 20minutes indicator light A6 goes off indicating the regeneration cycle has
been completed. It is recommended the regeneration been performed during the rest periods.
Version 270114
22