Control Panel - Nikken Air Wellness Traveler Guide D'utilisation

CONTROL PANEL

Panel lights
• POWER - Illuminates
when power is on.
• LOW - Indicates that unit is operating at low speed manual setting.
• HIGH - Indicates that unit is operating at high speed manual setting.
• AUTO - Indicates that unit is set in automatic mode.
• FILTER - Illuminates when filters require replacement.
• ION - Illuminates when negative-ion generator is active.
Buttons
• POWER - Used to activate or turn off unit.
• MODE - Selects low, high, or automatic mode.
OPERATION
Preparation for use
The Air Wellness Traveler may be used almost anywhere: home
or office, or in a mobile setting such as an automobile or
recreational vehicle. The Traveler may be placed on its stand or
attached using the straps on the case.
When used in a vehicle, for safety the Traveler must be securely
attached to a surface.
WARNING: Do not attach the Traveler against any surface
containing an airbag.
In an automobile, the straps are used to attach the Traveler to the
back of any seat that has an exposed back.
• Place the Traveler behind the seat back with the face of the unit toward
the rear of the vehicle.
• Pass the upper strap underneath the seat headrest and tighten so
that the strap is held securely between the headrest and the top of
the seat back.
• Pull down the two lower straps so that they reach down the back of
the seat. Pass the straps through the space between seat cushion
and seat back, and up the front to the top. Pull underneath the
headrest and attach to the Traveler case using the snap fasteners.
To use the Traveler in a stationary environment, place it on its stand and connect to power
source with the AC adapter/connector.
USING THE AIR WELLNESS TRAVELER
The Air Wellness Traveler can be operated in automatic or manual mode.
In manual mode (low or high speed), the Traveler runs continuously.
-4-